Basic instructions for weaving a ski cap for adults in a loom weaving
Supplies for making two hats of adult size:
1 Large round loom (Knifty Knitter or anyone with the number and spacing of same peg)
2 - ball Stamen yarn weight but should two skiens as it will work with two lines in all.
1 Loom hook
1 Needle yarn
Instructions:
Using two strands of thread throughout. (If you use a yarn skien.) It is best to wind in the middle of the ball of thread into a ball to have two trends. (Or use two madejitas)
1 - Final adjustment of the yarn around the spike protruding from the side of the loom. E-Wrap the thread of clockwise around the back of the first peg and all the pegs of the clockwise around the loom, which is why there is a loop (two lines) around each peg. Not fit closely, leaving little room for delay when extracted the final stitch over the top moves easily.
2 - Click now these loops down by what they are at the bottom of each peg. Wrap each peg in the same way that a clockwise as before, and more. Two loops should now have on each peg.
3 - Using the loom hook on the upper loop and out of the spigot part later o in the loom, starting with the first peg which involved, pick up the lower loop with the end of the hook and extraction drop him. Now there will be a loop in the ear and a loop hanging freely a bit out of the spigot. This is the first stitch point.
Repeat this step until you are woven throughout the row. Once reached the end, where each peg has a loop again.
4 - Now repeat row 1-3 again to repeat the process of adding a second loop for each peg and remove them in the same way.
Continue here until you have around 12 rows in the loom.
Hang Hem:
You can do the hem or edge of the hat. Pull the first row point back in plugs, a stitch at a time. It will be from the center of the loom. Once again there will be two points of stitches in each peg. Weaving was a stitch at a time around all the way. (It has completed the brim of hat)
Now continue knitting in rows 1-3 and another more rows of 12 to 16. When is hat long enough cut the yarn leaving a good 18 inches. Used "chain off" and meet the top of his hat.
Chain off: the strand of thread yarn needle thread left at the end of the upper part of the hat. East yarn in a large plastic eyed needle and use it to collect all the loops in the plugs (must be a loop by peg to do so). POKE the needle with the yarn through the stitch, throw the stitch the spike in the strand of yarn. When you have all the loops in the loom and the strand of yarn, pull the thread closely and take a little knot. You will now see your hat is completed, you can add a pom pom to give a nice finished look or make it clear.
Protect the upper part to tie a knot and a little Knitting yarn in to end the points of suture through hat cut strand of thread remaining. Woven thread beginning at the top and cut off the excess. There have only a hat of loom weaving. Use different sizes looms hats of different sizes.
Linda Spangenburg is based on 35 years of its fabric and crochet business experience, both as teacher and owner of a craft business. Find patterns for loom point is the author behind "Looney for looms". Do we hope to find the information here enough inspiration to try a business of crafts at home? You can find more free information about knitting and crochet for profit in http://www.knitting-n-crochet.com
No comments:
Post a Comment